Zircon Mould Rack System

QORVANIX Automated — floors that fetch

Heavy storage is where guesswork gets expensive fastest; the Zircon removes it — beam sections chosen for concentrated steel realities and roll-outs rated with the shelf extended, which is the only rating that matters.

Racking is structural engineering sold by the bay: cold-rolled profiles in certified steel, welds inspected to weld-class, and powder coat in RAL 5010 gentian or RAL 7016 anthracite over proper pre-treatment. Every configuration is designed by the manufacturer to EN 15512, tolerated to EN 15620, and delivered with the load plaques that make an inspector nod and move on.

Design & Craft

• Coil, die and mould racking with stated point loads
• Tolerances to EN 15620; load plaques per bay included
• Powder coat RAL 5010 / 7016 or hot-dip galvanised
• Anchors sized to your slab; torque schedule documented
• Beam sections chosen for concentrated steel realities
• Designed to EN 15512; manufacturer's documentation per configuration

Specifications

Care

Keep load notices legible, anchors torqued to schedule, and never exceed stated beam loads even briefly. Damaged components are replaced, never straightened — racking is repaired by part, not by apology.

Questions, Answered

Can I extend the system later?
That is the design intent: bays extend and beams re-pitch on 50 mm steps within the same system — keep your configuration documents current as it grows.

What about rack inspections?
Racking in use should be inspected regularly by a competent person in line with EN 15635. Damaged components must be replaced, never straightened.

The QORVANIX Promise

Modular systems reconfigure as your warehouse changes — bays extend and beams re-pitch without scrapping the steel.